urbine flow meters

1. The wiring position of the turbine flowmeter should be as far away as possible from electrical noise sources (such as high-power transformers, motors and strong power lines) and avoid parallel wiring with power lines.

2. Use a complete cable as much as possible.

3. It is recommended to use non-soldering clamp lugs at the end of thick wires.

4. In order to waterproof and mechanical damage, put the cable into the metal conduit, but there must be no high-power transmission cable in the same conduit, (when the power transmitted by a transmission cable is 10 times greater than the minimum power transmitted by the flowmeter signal cable , The two cannot be installed in the same conduit).